#Pace sidetalk 1023b manual
#Pace sidetalk 1023b plus

If the files with or icon will not display see the Site FAQ for help.

The only rub is that the 'S' meter reading is very 'stingy' on AM. TIPS: You need to have Acrobat Reader version 5 or newer installed to view the files with icon. Might there be a component that could be bad in the meter circuit on AM that I am overlooking? I love using this old radio, it's a nice clean vintage unit, and it talks quite nicely. the end sometimes means the Base version of an otherwise identical mobile chassis (Midland 13-862 & 13-862B, Pace Sidetalk 1000M & Sidetalk 1000B, etc. I did a receive alignment, but didn't really change anything for the meter movement on AM.

#Pace sidetalk 1023b manual

1975 Pace Cb Radio Service Shop Manual Model Sidetalk Cb-1023B. On SSB, the meter reads as it should (S-9+), with audio clear and loud. Pace Sidetalk CB-1023 CB Radio with Single Side Band. Pace 23 Channel Sidetalk CB-1023B SSB/AM Transceiver Base Station eBay People who viewed this item also viewed Showing Slide 1 of 1 EUC Realistic Navaho TRC-432 CB Base Station with Mic 119.85 + 29.45 shipping Vintage President AM-SSB Washington Transceiver CB Radio Base Station Untested 89.95 + 29.

The receive audio is great, clear and loud. The trouble is that on AM, when receiving a strong close range signal (S-9+), the meter shows only about 3 'S' units. Either it never was, or it was made after SAMS quit. I didn't really see any board number anywhere on it, if I locate it, I'll post it. The letter B at the end sometimes means the Base version of an otherwise identical mobile chassis (Midland 13-862 & 13-862B, Pace Sidetalk 1000M & Sidetalk 1000B, etc.) 4.

#Pace sidetalk 1023b plus

I cleaned it up, did a tuneup on it, and lined up all the crystals so they are on frequency, for the most part (this radio goes up to 27.605, plus the 'blank' channel on the dial is a functioning channel, channel 24). (1) Remove unit from its cabinet and locate the metal strip on the bottom side of the board and solder the small wire jumper as shown.